How to make good choices for the thicker processing of feeders is a question for many people. Before answering this question, Sanyi Xiaobian summarized the information in many aspects and made some conclusions. I hope these summaries can be useful to everyone. help:

Three-in-one feeder short process production line

Compared with split-type thick plate stamping production lines, the short process stamping production line of triple-feeder is indeed more expensive, but the three-in-one feeder triple machine structure takes up a small space, and the space for the workshop can be greatly improved. Saving, complete feeding, leveling, feeding complete automation completely without manual assistance, the entire debugging process usually only takes ten minutes to complete, saving time and energy, the press arm, folding arm, photoelectric sensor device added The material frame is partially unwound and it is always tightly fastened. It is almost non-relaxing and can be fed in a long dimension without curling.

At the same time, the structure type of the three-in-one feeder, which is arranged on one head, makes the leveling and feeding complete synchronization, fundamentally ensures the leveling and feeding accuracy, and the applicable material thickness range is also greatly improved. The material thickness can reach 12mm, and the three-in-one feeder achieves a high degree of integration of functions, has a perfect protection, lubrication system, all parts have undergone special processing, wearing parts very low consumption, great service life The extension has greatly improved the efficiency and quality of stamping processing. At the same time, the operating and maintenance costs of the entire production line have been greatly reduced. This is the best choice for the current heavy plate stamping production.

Split plate stamping production line

With the development of stamping automation, the heavy plate stamping production has also been gradually applied to the automated processing line. However, this production line is basically a split type structure. The heavy-duty material frame is used to carry the reel, and the reeling is performed. The plate leveler carries out leveling and internal stress on the material belt, uses a thick plate NC feeder to feed material, and then uses a large tonnage punch press to complete the production. This processing method also realizes the automation of the thick plate processing, but the entire process The production line not only has many equipments, the process flow is complicated, and the layout space is extremely large. Moreover, the operation is very tedious (many people are required to assist in feeding, feeding, and operation), and a long debugging time is required. At the same time, the leveling and feeding machines are separated. The poor synchronism of the formal layout results in the final leveling and feeding accuracy generally failing to meet the requirements. The split type heavy plate stamping line consumes high wearing parts and requires special maintenance, which makes the high cost of operation in the later stage of the whole line, and it needs to be not small. Capital investment.

Stamping industry in addition to commonly used in the processing of thin sheet material production, in many cases also need to use thick plate material for stamping production, the so-called thick plate usually refers to the thickness of more than 3.5mm sheet, such plate stamping process of traditional All of them use externally purchased sheets, and then many people carry out manual delivery. This type of processing and production not only has high cost for outsourcing sheets, but also has a large labor intensity, low feeding accuracy, and low production efficiency. There is still a great potential for security and it is completely impossible to apply modern production.