1. When loading the machine operator, pay attention to whether the lid of Feida is fastened so as not to damage the suction nozzle. When the material is loaded, it is necessary to distinguish between the tape and the paper tape feeder so as not to cause bad suction.

2, when the feeder up to the mounter should pay attention to see if the hook is fastened, such as buckled immediately after the shaking should be replaced Feida, and then to the placement machine feeder maintenance personnel.

3. If there are scattered feeder parts in the z-axis of the mounter, the maintenance personnel should be informed immediately, and it is necessary to open the feeder after inspection. If the high-speed Feida should check whether the inner lid can be operated in the opposite direction, if it is possible, it must be changed. If it is a medium-speed feeder, it is necessary to check the beak to see if it is worn out. If so, change it so as to avoid unnecessary throwing.

4. For the time being, feeders must not be fastened to the lid, and they should be placed back on the Feida storage rack as required. When transporting the placement machine feeder, it is necessary to carry it by hand when it is close to it, and to carry it by trolley when it is far away. However, the overlap of feeders must not exceed 3 so as to avoid deformation.

5. The defective placement machine feeder shall be affixed with a red label and sent to the maintenance office for maintenance personnel to handle.

6, the placement machine Feida can not arbitrarily mess with other labels, the lid can not be randomly placed after use.

7. All placement machines on the Z-axis feeder must be good, not floating or high.

8. Important Note: Any placement machine Feida may not use any parts if it is found missing.