Three easy intelligence to take you to understand what is the use of feeder characteristics and performance characteristics?

The feeders, which are divided into placing and feeding, vacuum feeders and triple feeders, will explain the features and performance characteristics of the three-in-one feeders in use today:

The three-in-one feeder is used by most enterprises and is a kind of high-tech equipment. The feeding machine with unwinding, straightening, and feeding as a whole is called a three-in-one feeder. Isn't it possible for us to use three-in-one feeders? Today's introduction is mainly to resolve some of the difficult problems that users encounter when using them.

1) After setting the feed length, look at the actual situation and set the feed rate accordingly. The method of setting will be described in detail later.

2) When the guide pin tip enters the guide pin hole in the mold, it can be adjusted to loosen the screw rod until it touches the bearing of the loose bracket until the material is relaxed, and the screw nut is locked (the pneumatically-relaxed feeder should be adjusted A good relaxation angle, that is, about ±15° below death.)

3) After the relevant parameters of feeding are set, the actual feeding length is not the same as the set value due to the factor of the number. Therefore, in the manual mode, press the feeding test, press, stroke, stamping, and adjustment. The actual length of the feed.

4). The role of pressure spring is to exert pressure on the upper roller, so that the upper roller can suppress the material and send the material out, so the pressure should be based on the principle of the material will not slip, the material pressure should be greater

5). After the setting is completed, it should be a single punch test mode, after adjusting it can be continuous production.

6) Turn on the corrector or material holder and slowly release the material.

7) Put the relaxation handle on the stage and place the material between the upper and lower rollers, lower the release handle, loosen the fixing screw of the material thickness adjustment handle, and adjust the handle up and down so that the relaxation bracket has a swing clearance of about 5mm, and then fix the handle with a screw lock tight. (Note: If there is no clearance for loose brackets, the material will not slip tightly and slip, resulting in inaccurate feeding. If the thickness of the material changes, it must be readjusted.

8). The adjustment of feed start is adjusted by the rotary cam of the press. The feed start signal is the angle of the crank press cranking. The recommended feed angle of the machine is 9 to 3 o'clock (240°-90). °)

What are the performance characteristics of the feeding leveler?

The feeding leveler is an automatic leveling extrusion of the material during the stamping process and achieves a leveling effect, usually applied in the industry. What are the main features of the feeding leveler? The following are the main points.

1. Feeding leveler High rigidity mechanical structure, high horsepower output. Can be used for high-speed and stable feeding, improve production efficiency, and extend the life of equipment.

2. Adopt large cylinder press material, adjust and adjust synchronous worm gear and worm adjustment. One rotation of the handle, the correction of the upper wheel only down 1mm for fine adjustment.

3. The corrective wheel uses solid bearing steel, high-frequency heat treatment after grinding, hard chrome plating, after the correction of the machine is smooth and smooth without indentation, does not damage the surface of the material;

4. The feeding leveler can be used alone, and it can be used together with MT type, MTD type automatic feeding rack, and the effect is better;